are the mibs on here?

[zorgon]

, but I need to get the Kindle formatting of My book done. 

By all means  first things first  EG can wait a bit longer

It ain't going anywhere

[robomont]

lmao, zorgon that was good.

but what if i like banging my head against the floor?
it allows my skull plates to stay flexible so my brain can keep growing.

[Littleenki]

lmao, zorgon that was good.

but what if i like banging my head against the floor?
it allows my skull plates to stay flexible so my brain can keep growing.

Hehehe! Theres more than one way to melt your brain, Robomont!:D

Try building the lifter in a closed shop and breathing ozone for a couple hours, trying to figure out how Eg will make a ten ton craft fly! Frus-trating!

Le

[robomont]

ozone,plasma,hv,a thousand ways to die.
so will alot of teslas stuff.
stubborn men do stupid stuff,and sometimes it works.my guess the voltage range is going to be higher than ozone,probly more like xrays.
i wish somebody could use xray film on a ufo.that could be very telling.

[Amaterasu]

Ama, you work on the sketches; there are no problems,lass, only solutions; as the old cliche' goes,where there is a will, there is a way...


seeker

I will indeed.  Tomorrow.  Too bushed from long day reformatting a book.

[Amaterasu]

how strong a dialectric do you need.teflon isnt high enough?

What K is it and can the K be made non-linear?  (i.e., low K at one end, high K at the other.)

[robomont]

i dont know the k but the white cutting board plastic is pretty high.thats teflon and it comes in different thicknesses.pure water is also high.it will store lightning if the water is at five atmospheres.i use to work with voltages of 17000 volts ac and lower at high current.as an assembler.

[PLAYSWITHMACHINES]

A dielectric is not per se an insulator, the best dielectrics are metals & ceramics

[Amaterasu]

Ok, will post a thread with pic. 

[Littleenki]

Otherwise, we could just wrap some plumbing tape around our forms and make dielectrics with that...any ideas on that PWM?

I have lotsa tape!

Le

[Amaterasu]

Post is up: http://www.thelivingmoon.com/forum/index.php?topic=2896.msg40332

[robomont]

we would use red fiberglass 2x4 with holes drilled in them to route hv cable.it would break down/decompose in about ten years.

[Back]

Hi All
I have been lurking for a few days reading post ect and trying to find the best place to post.

I will throw this question out there.

What form of electronics can survive an EMP burst.

I love my electricity and want to be prepaired if it happens

My understanding is anything anything in a circuit would be fried.
Electronic conponets not in a circuit would not be affected.

Any links or facts on this?

Bless
Back

[zorgon]

Put a faraday cage around your house 

Or at least line the room with your main stuff.  A metal mesh like used for stucco work would do it  ad long as its complete and grounded


Drywall mesh

OR you could buy military EMP rated electronics 

Not cheap and mostly still classified though

Other alternative is go back to tubes


What you need to know about EMP preparedness...

EMP 101: Part IV—Faraday Cages

Faraday Suit  -- Face the Tesla coil and become a Tesla Knight

[Back]

Really
My understanding is an EMP could penetrate a Farade cage
That why I was I was asking
Wish I could remember the link that said so
Back