First PEGASUS EXPERIMENT

[robomont]

yea danmed if you do danmed if you dont.
i only need the first level of ionization.dont want to melt the boiler.
i think ill go with just the 1/2lb.for now like you said.
mercury is basically caustic with so many metals otherwise i would put a pressure gauge on it.
i had my date wrong august 14th is the correct date for 90days.
i was hopin seeker would get back to me on a general idea of prices for that tubing he was talking about.regardless the show must go on.
i am 100% determined to make a try at this.
it sure would be nice to get some result.

the next project after this is going to be a magnet motor.probly this fall.

[PLAYSWITHMACHINES]

the next project after this is going to be a magnet motor.probly this fall.

Just don't try my one, it didn't work too well....

[robomont]

i think where everybody is going wrong is there has to be magnet kill switches.if you wrap a magnet with a copper coil and send nine volts dc through it then the magnettic field will die.by mounting a cometator on the end shaft to time the pulses then the machine would not run up.once a load is put on shaft then cometator can be bumped up a little but the main thing is the timed kill of each magnet at the proper time.if i build one there will two kills at the same time on opposite sides of wheel so it stays balanced.the 9v battery will be charged by the generator.
once i saw that magnetic fields could be forced to collapse using small dc voltage.i knew i had the answer.if you know of a vid that uses something like that.please point it out.because in my mind.the thing absolutely would work.

[PLAYSWITHMACHINES]

You are essentially correct, Robo old mate

Only these magnets are very strong, so i will need quite a big coil (volts not amps) to momentarily squash the field...
Good to see all that green stuff hasn't melted your brain yet, buddy

[Amaterasu]

I might point out that the "green stuff" is neurogenic - it creates neurons, not destroying them as alcohol and many other "drugs of abuse."

[robomont]

i remember seeing a show that had video of magnetic boots.a nine volt battery powered a coil in each boot.the coil was large diameter wire.i would think cheap magnets would make a decent first generator.

[Fruitbat]

Not sure whether you can quench a magnetic field using less energy than you'll get out of the generator side, but it's gotta be worth a go.

The other way of turning a field off is to use shielding material. I am told that the best magnetic shielding material in existence is used inside of hard drives, and so is free for the cost of mining it.

FB!

[robomont]

yes .quenching two magnets out of sixteen at any one time while the rest are pulling /generating should be easy.plus the magnets dont need to be mechanically angled or mechanically timed.just an electric switch.

[robomont]

another piece of history i found to add to my theory."caduceus ,the dragons of flamel",i was researching nicolas flamel and the sorcerers stone and came across this quote.as i believe the dragons of lore are ufos and the mercury caduceus engine is used in ufos this quote made sense.

[1Worldwatcher]

Howdy Robomont.

As for the Flamel connection, that's out there, but not unheard of my friend. Look at our tech today and Star Trek, very coincidental, or maybe not?

I did quite a bit of research into "Pinched Electromagnetic Fields" and there are a few things out there, but nothing that is really exacting for the research. Boyd Bushman from Lockheed did a on-sight experiment with a couple of stones that were exact in weight and similar in shape, It may have been a plaster cast that one was hollowed out and the other left to created weight, then the hollowed out one he took two plate rare earth magnet's and ran a piece of all thread through the center, putting the faces of resistant charges face to face, tightened down some nut's to the magnet's, forcing the "Pinch" with in Magnetic field and then had 10 separate students from the campus, none of them physics oriented students, then proceeded to drop them simultaneously from a 30' tall drop.

As he conducted the tests, and much to his surprise, 9/10 students watched the magnet's drop ten times each and apparently chose the Magnet filled rock/cast as being slower than the Solid one, so there must be something there with in "Pinched magnetic fields" too be apparently 'Noticeable'.

I have seen some Spectra-graphed anomalies when two magnet's are put in this circumstance as well, there was a huge increase of magnetic Fields parameter differences between the the 'Pinch' states, i.e. 3", 2", 1" etc., etc., the field got bigger as the magnet's became more tightened to one another.

Think it should be fare too mention that the students that participated in Bushman's experiment actually said the magnetic filled rock fell a full 2-3 seconds slower to their perception.

Have you ever gotten a drawing or rendering done for your design too post here yet robo? And as FB had stated, "Go for it!!" One only can get answer's that one needs of what too do and what not too do.

1WW

[robomont]

no i may post a design once i scavenge the parts.i went to the science forums site to get a number cruncher and had no luck.got shotdown on my blackhole theory but no big deal.im not building a blackhole.my speciaty is high voltage and it was because of those skills that allowed me to see the obvious of the caduceus design.it made common sense to me.even though the knowledge is not common.
i dont understand magnetics that well .thats why im lookiing for someone with magnetic field experience.but i know what a solenoid is and thats what the snakes are.obvious to any electrician.im 70% in belief the first "thing" i build will work.
its going to be small and simple to keep cost low.just hope my two angel investors come through for me : )
otherwise it take a little longer.im determined though .we will get good results or bad results but we will have results.

[ArMaP]

As he conducted the tests, and much to his surprise, 9/10 students watched the magnet's drop ten times each and apparently chose the Magnet filled rock/cast as being slower than the Solid one, so there must be something there with in "Pinched magnetic fields" too be apparently 'Noticeable'.

Don't forget that, on Earth, all magnet experiments are being done inside the Earth's magnetic field, that's why magnets point to nort/south, as you can see in the video below.



PS: sorry for any advertisement, I was given the possibility of having adverts in my videos, so I'm using it.

[ArMaP]

no i may post a design once i scavenge the parts.i went to the science forums site to get a number cruncher and had no luck.got shotdown on my blackhole theory but no big deal.im not building a blackhole.

Let's hope you're right about that.

i dont understand magnetics that well .thats why im lookiing for someone with magnetic field experience.but i know what a solenoid is and thats what the snakes are.obvious to any electrician.im 70% in belief the first "thing" i build will work.

Aren't there too few turns for the snakes to work as a solenoid?

[robomont]

the oldest designs have a minumem of five turns x two tubes for a total of ten wraps.thats why i want a specialist in magnetic fields to see it i need more smaller diameter tubes or just some larger less wraps.gonna be researching it more before august gets here.ive pretty much got the amount of energy input that needs to be though.one horsepower will be more than enough and thats  not even one whole kilowatt.746watts is one horsepower.i may be able to use a hotplate or a propane rosebud for heat .depending on test location.the heat should build up quick as its a sealed system.my biggest worry is it does work and ends up landing on a house and killing the occupants.thats why im looking for a remote area.ive got plenty to choose from though.

[1Worldwatcher]

robomont wrote:

my biggest worry is it does work and ends up landing on a house and killing the occupants.thats why im looking for a remote area.ive got plenty to choose from though.

Yes, lets not go down this road of research, maybe scale model would be more cost efficient as of right now anyway? You can always scale up after initial tests and trial runs are made robo, just be safe when trying usable models as far as size goes, could get hairy.. 

1WW